High speed cine observations of cavitating flow in a duct

The dynamics of cavities produced in cavitating flow confined in a duct was studied. The ultimate purpose of the work is to develop models of the flow to assist in predicting cavitation erosion and noise. Observations of the cavitating flow using high speed cine photography allowed confirmation to be made of the shedding mechanism originally described by Knapp, and measurements of the cavity dimensions to be determined as a function of time. It was found that the time for a cavity to collapse was found three times greater than expected from Rayleigh's classical theory.     

Cavitation Research and Ship Propeller Design

The role of cavitation research in the design of ship propellers and the influence of research on propeller design is reviewed. The historical development of research on bubble cavitation is an example of a lack of communication between research and design. Research on sheet cavitation is starting now and simplifications such as two dimensional cavitation are being made. It is argued from observations on propellers that the use of two-dimensional cavitaties is not a proper simplification to investigate sheet cavitation. An illustration is also given of the gap between the assessment of the risk of erosion on propeller models and research on erosion. Finally, the simplifications of tip vortex inception and the problems of the inception speed of propellers are discussed.     

瞬态空化泡演变过程的数值模拟

采用边界积分方程方法，对无粘流体中三个空化泡以及自由面附近二个空化泡相互作用的演变过程进行了数值模拟。计算中边界用二阶有限元离散，影响系数矩阵非对角线元素用六点高斯数值积分方法计算，对第一类、第二类完全椭圆积分用高次多项式近似，对计算系数矩阵对角线元素中遇到的奇异积分进行了特殊处理。结果表明，在不同的给定参数下，空化泡的溃灭形态各异，柱状射流和环形射流都有可能发生，使空化泡演变成双泡或环形泡。     

液电冲击波的实验研究

本文用水下电火花微爆炸产生重复性极佳的球形冲击波,用双曝光全息干涉法测量了液电冲击波的传播,并观察到冲击波与水下电极之间的相互作用.实验结果表明此法适用于液电冲击波的测量,特别适用于由冲击波波前位移来确定其峰值压力分布.     

Generation and evolution of cavitation in magma under dynamic unloading

The full system of equations for the problem of rarefaction-wave passage over the magma-melt column in the gravity field is derived with the use of the kinetic theory of phase transformations, and the problem is numerically solved. With allowance for diffusion zones and nucleation frequency as a function of supersaturation, the dependence of the number of cavitation nuclei formed in the course of phase transformations behind the rarefaction-wave front is found. The dynamics of the size distribution of cavitation bubbles along the magma-melt column (1 km) whose viscosity varies dynamically as a function of the concentration of dissolved water is studied.Translated from Prikladnaya Mekhanika i Tekhnicheskaya Fizika, Vol. 46, No. 2, pp. 71–80, March–April, 2005.     

冲击波作用下乳化炸药压力减敏的表征方法

引入一个新的物理量压力减敏程度,来更合理地表征乳化炸药发生压力减敏的难易程度,为研究其作用机理提供量化的分析工具。分别利用乳化炸药发生压力减敏前后的爆炸冲击波峰压及其对数、冲击波能量和总能量计算压力减敏程度,比较并分析计算结果的优劣。结果表明,几个参数计算的结果都能达到相近的效果,用冲击波峰压计算起来简单方便,冲击波能量计算效果较好。用冲击波参数计算的压力减敏程度能够反映乳化炸药压力减敏的本质,建议采用冲击波峰压计算压力减敏程度,在数值差别不明显时采用冲击波能量来计算。     

建筑物爆炸泄压的试验研究

本文报导了在1米~3和30米~3两个爆炸泄压试验装置内进行的360余次试验结果。证明了在有平行壁面的建筑物内发生的可燃气爆炸泄压过程中,声动不稳定燃烧压力峰P3是建筑物的主要破坏因素。试验表明,本文发展的一种爆炸减压板具有消除P3的效应。     

Damage characteristics and surface description of near-wall materials subjected to ultrasonic cavitation

For the analysis of ultrasonic cavitation erosion on the surface of materials, the ultrasonic cavitation erosion experiments for AlCu4Mg1 and Ti6Al4V were carried out, and the changes of surface topography, surface roughness, and Vickers hardness were explored. Cavitation pits gradually expand and deepen with the increase of experiment time, and Ti6Al4V is more difficult to erode by cavitation than AlCu4Mg1. After experiments, the cavitation damage characteristics such as the single pit, the rainbow ring area, the fisheye pit, and some small pits were observed, which can be considered to be induced by a single micro-jet impact, ablation effect caused by the high temperature, micro-jet impingement with a sharp angle, and multibeam micro-jets coupling impact or negative pressure in the local area produced by micro-jet impact, respectively. The surface roughness and Vickers hardness of the material increase slowly after rapid growth at different points in time as the experiment time increases. With the increase of the ultrasonic amplitude, both of them first increase and then decrease after the ultrasonic amplitude is greater than 10.8 μm. The increases in surface roughness and Vickers hardness tend to decrease as the viscosity coefficient increases. Ultrasonic cavitation can cause submicron surface roughness and increase surface hardness by 20.36%, so it can be used as a surface treatment method.     

Application of persulfate with hydrodynamic cavitation and ferrous in the decomposition of pentachlorophenol

Hydrodynamic cavitation (HC) and Fe(II) are advanced oxidation processes, in which pentachlorophenol (PCP) is treated by the redox method of activating persulfate (PS). The kinetics and mechanism of the HC and Fe(II) activation of PS were examined in aqueous solution using an electron spin resonance (ESR) spin trapping technique and radical trapping with pure compounds. The optimum ratio of Fe(II)/PS was 1:2, and the hydroxyl radical (HO) and sulfate radical (SO₄⁻) generation rate were 5.56 mM h⁻¹ and 8.62 μM h⁻¹, respectively. The generation rate and R_ct of HO and SO₄⁻ at pH 3 and 50 °C in the Fe(II)/PS/HC system are 7584.6 μM h⁻¹, 0.013 and 24.02 μM h⁻¹, 3.95, respectively. The number of radicals was reduced as the pH increased, and it increased with increasing temperature. The PCP reaction rate constants was 4.39 × 10⁻² min⁻¹ at pH 3 and 50 °C. The activation energy was 10.68 kJ mol⁻¹. In addition, the mechanism of PCP treatment in the Fe(II)/PS/HC system was a redox reaction, and the HO⁻/SO₄⁻ contribution was 81.1 and 18.9%, respectively. In this study, we first examined PCP oxidation through HO and SO₄⁻ quantification using only the Fe(II)/PS/HC process. Furthermore, the results provide the foundation for activation of PS by HC and Fe(II), but also provide a data basis for similar organic treatments other than PCP.     

碟形超声变幅杆的设计

优化超声变幅杆的形状结构可有效地提高水域声场分布和空化区域,提升对水域超声空化效果。通过模拟分析发现传统超声变幅杆在水域中具有声场分布均匀性差、变幅杆端部声压高等特征,不利于声波在水域中传播。基于此,提出并优化设计了一种具有碟形结构的变幅杆,位于变幅杆的最大振幅处的碟形结构,有更大的振动位移;模拟表明其水域声场和声压均衡度显著优于传统变幅杆,铝箔空化腐蚀实验进一步证实了其水域中的声压分布均匀性。同时,实验通过铝箔的空化腐蚀、KI剂量测定及工件表面油渍去除对比了传统变幅杆和碟形变幅杆,分析表明碟形变幅杆所在水域中有较大的空化腐蚀区域,腐蚀速率明显提升,声化学反应速率提高,油渍去除程度增强,说明了设计的碟形变幅杆能够促进空化泡的产生,增加水域空化区域。